Developed for 10Gbps high speed applications (standard SFP reaches limit at 4.25Gbps) 10 Gigabit Ethernet Fibre Channel: 1, 2, 4 and 8G FC Infiniband SDR, DDR and QDR Fibre Channel over Ethernet (FCoE) Component requirements Enhanced EMI skirt...
CABLE S-PARAMETERS THROUGH MEASUREMENT
Cable S-Parameters through Measurement setup is shown in Figure 4. The through measurement setup shown is for cable end B to cable end A with the response measured B’ to C’. The procedure is then repeated to measure cable through response from end A to...
CABLE S-PARAMETERS CROSSTALK MEASUREMENT
Cable S-parameters crosstalk measurements setup is shown in Figure 5. The crosstalk measurement setup shown is for the cable end B measured from B’ to C’. The procedure is then repeated to measure cable crosstalk for the other end. OC3/STM-1 SFP transceiver
S-PARAMETERS TEST METHOD PROCEDURE
In order to calculate the cable parameters as defined in SFF-8431 table 37, following test procedure is required: •Measure S-parameters for MCB-HCB from point B” to B, see 3.1.1 •Measure the s4p for through S-parameters for cable end 1 to cable end 2, see 3.1.2...
SFP+ ACTIVE CABLES TYPE I (FOR OPERATION WITH A LIMITING HOST)
SFP+ Active Cable’s Type I are assemblies that operate with the SFP+ limiting hosts defined in Chapter 3 of SFF-8431. Specifically, the active cable input must satisfy the SFP+ module transmitter input specifications at B’ in Table 16 of SFF-8431 and tolerance specifications at B”...
SFP+ ACTIVE CABLE HIGH-SPEED ELECTRICAL SPECIFICATION
This section defines the high-speed electrical specification for implementations with limiting or linear outputs. Active Cables designed to operate with limiting hosts are broadly defined as Type I, while Active Cables designed toSFP+ (Active Cable Specifications and Alternate Test Methods) twinax cable sfp+
Active Cabling Specifications
are not specified by this standard, it is expected that SFP+ Active Cables operate with either linear or limiting hosts as defined in section X.2. An example of active cable assembly with active transmitter is shown in Figure 1. The cable assembly shown has an...
CHAPTER 2 ACTIVE CABLING SPECIFICATIONS
SFP+ (Active Cable Specifications and Alternate Test Methods) Page CHAPTER 2 ACTIVE CABLING SPECIFICATIONS 2.1 INTRODUCTION High speed cabling specifications are based on SFI signalling as defined in SFF-8431 supporting either a limiting or linear host. Active cable assemblies may be used to provide operation...
ESD
The active and passive cable assemblies SFI contacts (High Speed Contacts) shall withstand 1000 V electrostatic discharge based on Human Body Model per JEDEC JESD22-A114-B. The active and passive cable assemblies contacts with exception of the SFI contacts (High Speed Contacts) shall withstand 2 kV...
CHAPTER 1 SCOPE OF THIS SPECIFICATION
1.1 INTRODUCTION This specification defines cabling solutions compatible with SFP+ linear or limiting host for 10.3125 GBd operation based on “SFI”. For detailed SFI specifications and test methodology, see SFF-8431. This specifications also defines an alternative passive cable test method based on cable S-parameters. The...